Each stencil can be reused between 15-20 times depending on the amount of pressure, care of use, distance between the tip of the blasting gun and the stencil, and the type of abrasive (we recommend between 180-220 grit size preferably 220).
Oh, by the way...did we mention that you can also use these stencils with our Armour Etch glass etching cream, water based paints and even body paints. So check back with us often on the web, to keep up with our newest stencil concepts.
Preparation:
1. Clean glass and dry thoroughly.
2. Peel stencil from carrier sheet and position over glass. (If stencil does not lift easily from carrier sheet, place stencil under warm running tap water. Dry thoroughly, then continue)
3. Press stencil down and smooth firmly to the glass.
4. Cover the entire area around the stencil with wide masking tape, overlapping the edges of the stencil so there are no spaces or gaps. All remaining exposed glass should be covered and protected. Use with Armour Etch Cream or sand etch applications